Betta Tilecare Floor & Wall Primer for Waterproofing | 1 Litre (4 Buckets)

• Do not apply externally when rain is imminent
• Before commencing the application, adhesion of products to be used (primers, membranes, coatings) should be tested over a typical area of the prepared surface to ensure satisfactory adhesion
• Clean away surface residues from metals, glazed and plastic surfaces

• Do not apply over sealants such as silicon, polyurethane etc.
• Primer must be dried before over coating with finishes
• Not to be applied when surface temperature is below 100C or above 350C
• This product is a primer and is part of the Gripset Betta waterproofing system.

• For all waterproofing applications, this must be used in conjunction with the Gripset Betta range of waterproofing products.
• Not to be left exposed as finished membrane or sealer
• Not to be used as a membrane
• Do not leave exposed to UV for greater than 48 hours before applying finish product.

PREPARATION:

Surfaces must be prepared thoroughly before commencing. Surfaces are to be sound, stable, dry and clean, free of loose foreign matter including any surface residues or existing coatings. Buildings are to be constructed to relevant building standards and manufacturer’s recommendations are to be followed for all building materials used.

APPLICATION

Stir product well before using. Apply with a long bristle brush or short nap roller. General coverage is 1 litre/10m2 on general smooth even surfaces. On uneven rougher surfaces this may reduce to 1 litre/8m2 Before applying on metals, plastics or glazed surfaces, ensure all solvent or film residues are removed using a degreaser or similar.

DRYING